Real fix for timing cover seal – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

This topic has 2 replies, 2 voices, and was last updated April 12, 2012 at 7:26 pm by gtoner.

Viewing 2 reply threads

Author

Posts
- April 10, 2012 at 1:32 pm #57848
  gtoner
  There is a real solution to the timing cover seal problem which can be found on this site:
  
  http://joesrestorationrescue.com/
  
  I am personally involved in the development of this product and offer it as a matter of common interest to the Alpine community. I am of course biased by my involvement so no further opinions are offered. I will answer any questions either here on this thread or through the website, as long as I am not violating any forum rules.
  
  Regards,
  
  Gene
- April 11, 2012 at 1:54 am #64538
  impbarn
  Having already done this for my 1600 engine, I know its an involved engineering process with lots of machining. It looks like the troublesome standoff bolt in the center is eliminated as well.
  
  An off-the-shelf solution for 1725 is the perfect thing for the vast majority of the Sunbeam community. Very well presented as well. Thanks for sharing. I can’t wait to see one installed!
- April 12, 2012 at 7:26 pm #64542
  gtoner
  Check the website, the prices got reduced.
  
  Gene
Author

Posts

Viewing 2 reply threads

You must be logged in to reply to this topic.