LAT option Traction Masters or Traction Bars

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

This topic has 0 replies, 1 voice, and was last updated October 18, 2007 at 3:22 pm by Richard Creber.

Viewing 0 reply threads

Author

Posts
- October 18, 2007 at 3:22 pm #57037
  Richard Creber
  I am rebuilding my 65 Tiger which already has original traction bars on it from way back in the day (as listed in the B of N). I already had purchased some Traction Masters that were made in California…. by Traction Masters (original or not ?). Now, the traction masters, as you all know, fit onto the leaf springs. However, the traction bars are fitted in front of the rear axle somewhere and then to the driver and passenger floors.
  
  Question #1 : Which is better ? Do they both do the same thing ?
  
  Question # 2 : Should I leave the original set up and sell the Traction Masters… or use both…… or remove traction bars and replace with traction masters ?
  
  Thanks
Author

Posts

Viewing 0 reply threads

You must be logged in to reply to this topic.