Dash Removal – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

This topic has 2 replies, 2 voices, and was last updated April 8, 2015 at 3:35 pm by Dave and Carrie and Carrie Kulasa.

Viewing 2 reply threads

Author

Posts
- April 8, 2015 at 12:00 am #58302
  Dave and Carrie and Carrie Kulasa
  Participant
  Hi everyone I’m starting to strip my tiger down for restoration. Most things are off.
  I’m starting on removing the dash now. How many fastners are there holding it in.
  Does everything come out with it then you disconnect wiring.
  
  Dave K
- April 8, 2015 at 1:33 pm #66058
  Eric and Bonnie and Bonnie Gibeaut
  Participant
  Hi Dave
  There are about 6 large Phillips head screws holding the dashboard face in. Then remove the lower padded dash rail and turn signal switch and surrounds. Heater cables and oil pressure line must be loosened at the ends and then unplug the wiring harness from the gauges. Ease the dashboard back and remove anything else holding it in. I am sure I forgot a few things! Sounds simple but it isn’t-it will take some time and lots of patience! Good luck……..Eric PS-maybe you could then write up a tech tip for the next Rootes Review or do a tech session at our upcoming United?
- April 8, 2015 at 3:35 pm #66059
  Dave and Carrie and Carrie Kulasa
  Participant
  Thanks Eric. I’ll try and get some good pic of the project and do a write up. this way I’ll also remember how to put it back together.
  I’m excited about finely working on my car.
  
  Dave k
Author

Posts

Viewing 2 reply threads

You must be logged in to reply to this topic.