Factory Service Bulletin Header

GROUP: Engine
SUBGROUP: Intake Manifold

DATE: 10-14-68

SUBJECT: Engine Vibration

THIS BULLETIN CANCELS AND SUPERSEDES BULLETIN 67-45 DATED 4-3-67.

When you receive complaints of engine vibration which. can normally be felt through the accelerator pedal especially at 3200 r.p.m,. it is recommended that a clamp is fitted to the intake manifold in accordance with the following instructions:

  • Remove center bolt from intake manifold.
  • Remove the existing center bolt and replace with Imp cylinder head bolt, part #9003239 (3/8″ U.N.C. bolt).
  • Assemble washers, clamp, nut and spacers in order shown in figure 1, to bolt ‘F’.
  • Fit clamp assembly at position shown in illustration and tighten bolt ‘F’ to 20 ft. lbs. and then tighten nut ‘C’.
    NOTE: ALWAYS TIGHTEN BOLT ‘F’ BEFORE NUT ‘C’.

DESCRIPTION – PART NUMBER – QUANTITY

  • Plain Washer ‘A’ – 9068016 – 3
  • Spacer – 9088193 – 2
  • Nut ‘C’ 3/8″ UNC – 9029168 – 1
  • Clamp ‘D’ – 1214539 – 1
  • Lock Washer ‘E’ – 9661241 – 1
  • Bolt ‘F’ – 9003239 – 1

J.J. Rivers
Service Manager

image

Leave a Reply