Wooden Dash – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

This topic has 2 replies, 3 voices, and was last updated January 15, 2016 at 3:20 pm by Dan Richardson.

Viewing 2 reply threads

Author

Posts
- May 21, 2010 at 8:28 am #57539
  1-mad-john
  I bought a wooden dash from a tiger for my alpine ( to make it go faster ). It doesn’t have the little holes sticking out on the back like the plastic one does so how to you attach the vent and heater cables.
- May 21, 2010 at 10:30 am #63510
  jmthehermit
  You have to fab 3 small brackets to hold the two controls to the wood dash. You can get the spacing from the back of the Alpines bakelite dash. The center bracket will hold the two controls together and the two end brackets anchor the outer ends. The brackets are secured to the back of the wood dash by using the three studs of the heater/vent bezel. Jeff
- January 15, 2016 at 3:20 pm #66425
  Dan Richardson
  Participant
  I sell the Tabs for the Alpine Dash that does not have them. $30. delivered (US)
  
  Contact me at tiger2dan at gmail.com
  
  DanR
  
  Attachments:
Author

Posts

Viewing 2 reply threads

You must be logged in to reply to this topic.