Tiger door glass installation – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

This topic has 1 reply, 2 voices, and was last updated November 24, 2012 at 1:35 pm by Joel & Karen Griffin.

Viewing 1 reply thread

Author

Posts
- November 24, 2012 at 4:35 am #57925
  Carl Fronk
  I am assembling bare doors from scratch and am having difficulty attaching the glass bottom channel to the window regulator. I did not disassemble the doors and have read the Workshop Manual where they tell you to "Spring out the operating arms from their locations." I don’t see how that would have been possible, however my question is, how do you re-attach the regulator rollers (studs) into the lower glass channel?
  I would appreciate any help. Thanks…
- November 24, 2012 at 1:35 pm #64764
  Joel & Karen Griffin
  Participant
  From the rear of the door. remove the stop in the channel and slide the track forward from the rear button to the front also remember to install the outer seal and the inner anti rattle felt before the glass!
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.