The list below is shown with the most recent addition shown first.
Forums Table of Contents is here
Find all posts (listed not in a category but in order, newest on top)
-
-
Can anyone suggest a source for a rear hub puller? The shop manual I have shows a cone shaped puller that bolts tight against the hub using the lug bolts.
-
http://www.drivewerks.com/catalog/shopc … 68_pg3.htm
I use one like this works very well.
-
Thanks for the quick response. I’ll give it a try.
-
I pulled one shaft and hub out of the rear end and used a press to get it off- I bent the first one with a very strong puller and too much heat …. and discovered the 19 splines axles are hard to find good luck
-
Go to http://www.TigersUnited.com website and look up
the rear axle section. There you will find several
discussions on how to pull the rear hub.
Dave
- You must be logged in to reply to this topic.