Paint Masking Tip – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

This topic has 1 reply, 2 voices, and was last updated June 5, 2005 at 3:26 pm by anonymous.

Viewing 1 reply thread

Author

Posts
- March 27, 2005 at 5:50 pm #56384
  jim-d-amelio
  This tech tip involves a masking technique when re-painting a section of
  you car. Before taping the masking paper to the car, fold over about
  4mm of the edge of tape closest to the repair area onto itself, (so that
  edge doesn’t stick to the surface). When you actually spray the area to
  be repaired, the overspray will get underneath the fold and cause paint
  to feather onto the original paint. This makes it easier to sand the
  new paint into the old. Courtesy of Tom Wiencek.
- June 5, 2005 at 3:26 pm #59345
  anonymous
  That’s a good one…like that tip…thanks!
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.