The list below is shown with the most recent addition shown first.
Forums Table of Contents is here
Find all posts (listed not in a category but in order, newest on top)
-
-
I have global west control arm bushings and shafts; the problem I am having is the global west’s instructions contradict the shop manual (the shaft installation and spacing is different than the manual). Global west is no help they haven’t made this setup for ten years. I the Tiger shop manual in section F page 22 it states in bold print "IT IS VITALLY IMPORTANT THAT THE FULCRUM PIN IS FITTED SO THAT THE GREATER DIMENSION IS TO THE REAR ARM OF THE LINK"
I think that Global west messed up on there instructions, any help would be appreciated.
Thanks
Jim K
-
Tim,
Go with the manual instructions. John Logan
- You must be logged in to reply to this topic.