Horn Ring Not Working – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

This topic has 1 reply, 2 voices, and was last updated April 18, 2007 at 2:49 am by Bob and Jean Webb.

Viewing 1 reply thread

Author

Posts
- April 16, 2007 at 4:03 pm #56917
  mad-river
  Howdy all:
  
  Since buying my Tiger, the horn ring hasn’t worked. In adjusting the steering wheel, I discovered that the wire that leads from the horn bush to the blade on the inside of the steering collum was not connected. However, when I connected it, the horn was on all the time! I’d love some guidance on how to address this problem, and a good source of information/parts. Thanks!
- April 18, 2007 at 2:49 am #61233
  Bob and Jean Webb
  Participant
  if you remove the horn ring you will find that you probably need to adjust the gap between the horn ring and the ring behind it .there should be springs between the two.back the nuts off until you have a small gap between the two.then when you push the horn ring the two make contact and the horn works.if they touch all the time , the horn will blow all the time.
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.