Hood badge reproduction problem – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

This topic has 1 reply, 2 voices, and was last updated April 7, 2007 at 11:48 am by alpine-64.

Viewing 1 reply thread

Author

Posts
- April 6, 2007 at 5:55 pm #56915
  Robert and Mariet Jaarsma
  Participant
  Similar to the early style Rootes hood badges, the Sunbeam Venezia and may be others (although I have not found any others yet) has a Rootes group logo badge on the hstandard hubcaps. We have managed to make a silicon mold and cast the plastic badge. However we have not found a way to inlay the chrome in the lettering and hound dog. Chrome paint turns out ltoo gray, not the brightness we are after. Anybody has the know-how how this is (was) done? Thanks, Robert
- April 7, 2007 at 11:48 am #61231
  alpine-64
  Participant
  robert,
  
  i am doing some badges in perspec at the moment.. i was looking into :
  
  http://www.chromepaint.com/
  http://www.chromepaint.com/multichrome- … 3682bd3a5c
  
  http://alsacorp.com/products/mirrachrom … _price.htm
  
  quite expensive though!
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.