FUEL LINES – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

This topic has 1 reply, 2 voices, and was last updated April 16, 2005 at 1:21 am by jumpinjan.

Viewing 1 reply thread

Author

Posts
- April 14, 2005 at 8:45 pm #56410
  anonymous
  When I restored my Tiger I found the fuel lines plugged with dirt and other junk from the old gasoline.
  
  I took a piece of weed eater string and chucked one end in my electric drilll. I then started to feed the other end into the gas lines while running the drill motor at a medium speed. The weed eater string cleaned out the lines without damaging the inside of them, and was flexible enough to make it around corners and bends in the lines.
- April 16, 2005 at 1:21 am #59067
  jumpinjan
  Yes, but you still need to “blow” the line out with compressed air, I don’t really see the purpose of all that additional work? If one can’t blow all the junk out with compressed air, one usually replaces the line with a new one? Right?
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.