cover plate – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

This topic has 2 replies, 3 voices, and was last updated November 23, 2007 at 8:37 pm by Bob Hokanson.

Viewing 2 reply threads

Author

Posts
- November 22, 2007 at 4:36 am #57062
  alpine-64
  Participant
  Hi everyone. My Tiger has a Lakewood bell housing and cover plate, I
  notice it has 3 holes in the front of the cover plate.
  Is this for inspection? cooling? It seems that it would allow dirt, dust and
  moistureinto the flywheel, should i cover the holes?
  
  see the pic:
  
  http://good-times.webshots.com/photo/22 … 2410XXWGWG
- November 23, 2007 at 11:36 am #61751
  gtsmrt
  Hi Michael,
  
  Have you contacted the previous owner to find out whether the holes should be covered or for what reason they are there?
  
  Regards, Robin.
- November 23, 2007 at 8:37 pm #61752
  Bob Hokanson
  I’ve had a Lakewood bellhousing like that on my Tiger for about 15 years with the holes open and no problems. I think they are to help with cooling the clutch.
Author

Posts

Viewing 2 reply threads

You must be logged in to reply to this topic.