All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below
-
-
I just got this picture from my CNC guy. What do you guys think???
I have not fit it to the car yet but it should work fine. It uses a stock K&N E3515 filter
-
Looks great! A lot of work. Is the weight/height/etc about the same as the cast ones?
What did you use to "program" for the machine… start with photo, old cast type, or ???
Hope that the guy is very friendly, otherwise looks like it could be "co$tly" 
-
Impressive! Would like to see one OR mount on the shop’s trophy wall . . . .
-
Very cool! Looks great. Did you hog out any material off the bottom?
-
I am picking up the final tomorrow I post pictures when I get it home.
-
quote 66tiger289:
I am picking up the final tomorrow I post pictures when I get it home.
Luv to see same . . . .
-
Here are the Pics.. So far. We are still trying to iron out what it would cost to make more.
Pic 1
Pic 2
Pic3
Pic 4
Pic 5
-
Looks great, that is quite an achievement 🙂
What is next? – polish or paint or anodize??
-
Looks Great!
If it fits the car without hood interference I certainly would like to purchase one if the become available.
Gene
- You must be logged in to reply to this topic.
.
