Reply To: Your valve covers missing???

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

September 2, 2008 at 2:28 pm #62497

anonymous

I have the LAT finned aluminum valve covers so the engine label will not stick correctly to the cover.

I procured a new label and stamped the numbers on it. I then used a piece of sheet magnet with adhesive on one side and mounted the label to it.

The label is mounted on the "shelf" above the engine bay. If I need to remove it I simply peel it off and replace it later.

I’ve done this with all the dash plaques and other tags I want to keep on the car without ruining my already chipped and dinged paint. They make great covers for the defects in the paint.

Fred Baum