Hi Dave
There are about 6 large Phillips head screws holding the dashboard face in. Then remove the lower padded dash rail and turn signal switch and surrounds. Heater cables and oil pressure line must be loosened at the ends and then unplug the wiring harness from the gauges. Ease the dashboard back and remove anything else holding it in. I am sure I forgot a few things! Sounds simple but it isn’t-it will take some time and lots of patience! Good luck……..Eric PS-maybe you could then write up a tech tip for the next Rootes Review or do a tech session at our upcoming United?
Forums
All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below 