Re: Dana 44 detroit locker truetrac – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

November 14, 2014 at 12:10 am #65926

Gene Sokolowski

Participant

I have the axles back from the machinest. One and three eights inches total was added to the internal axle end in order to set the axle end float.

QUESTION: In the Tiger manual, Section G, Rear Axle it calls for setting the correct end float of .006 to .008 in. I ASSUME this is .006 to .008 in. for each axle. Since my Detroit Locker TruTrack does not have a spacer in between the axles like the original carrier would I set the end play for .006 to .008 in. total since the axles float totally from one side to the other? Or… ?????