TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

March 12, 2024 at 8:29 pm #100115

Tom and Joanne Ehrhart

Participant

Robert, I don’t have any photos at my fingertips but I think I can describe what you need. You need two brackets.

One bracket is “L” shaped with a hole on the base (or short end) of the “L” and the other two holes are on the long side of the bracket. The holes will align with the two holes on the side of the servo.

The other bracket is about the same width as the “L” bracket and slightly shorter. It has a 90-degree bend at both ends The one bend is also bent at slight angle to the long portion of the bar.

Trust this helps ……………….TT