Reply To: Front caliper upgrade – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

February 28, 2005 at 8:12 pm #58840

Chuck & Ollie Ingram

quote Jim E:

Chuck,
What is involved with the MII spindle? how is the offset does it keep the wheel in the same location or does it stick it out board more than it is already?

Jim
Questions,questions.
Jim I’m not that far as of yet.Im trying to find the floor and top of the bench right now.However I did hear of it being done.Hopefully I will have some vision of where I’m going on this.I think it was Tom Patton ??? who fitted mustang spindles.
Now that you asked I will measure the distance the hubs of the spindles are from the center line of the ball joints. Actually I wouldn’t mind if the mustang spindles are out further as the 8 inch rear end was never narrowed as it matched the mustang front end that was in the 62.
Isn’t all of this fun? 8) yep its sunny