Re: In need of some badge measurments – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

January 27, 2018 at 7:40 pm #66995

rfraser

Steve
To really get accurate measurements of this part you need an optical comparator.
The top edge has about a 3 5/8" radius and the bottom edge has about a 4" radius also I found 2 different size badges.

Center line vertical measurement #1 = 1.507" #2 = 1.552" this is not a value asked for but without making a square fixture to hold and measure this part – it’s the best I can do.
Top measurement #1 = 1.509" #2 = 1.555"
Bottom measurement #1 = 1.247 #2 = 1.298"

If your intent is to reproduce these Insert – Motifs; I suggest you email STOC UK to see if a drawing is available in the Rootes Archive.

All the inserts should be similar in measurements; here are the part numbers
Sunbeam 260 – 2234516
powered by Ford ? – 2231536
Sunbeam V8 – 2235726

Ron Fraser