Lower control arm bushing replacement - TigersEast AlpinesEast

The list below is shown with the most recent addition shown first.

Forums Table of Contents is here
Find all posts (listed not in a category but in order, newest on top)

This topic has 1 reply, 2 voices, and was last updated November 2, 2021 at 9:22 pm by Eric and Bonnie Gibeaut.

Viewing 1 reply thread

Author

Posts
- November 2, 2021 at 9:10 pm #87661
  
  Bob Williams
  Participant
  
  Does anyone know the dimensions of the special tool mentioned in the workshop manual which is Churchhill special tools that number Rg.318? I am looking for the dimensions for the slotted support tube to remove and install the bushings in the lower control arms. I hope that somebody has an idea of what size tubing that should be before I go out and buy tubing to make one.
  Thank you.
- November 2, 2021 at 9:22 pm #87663
  
  Eric and Bonnie Gibeaut
  Participant
  
  Club member Doug Jennings has all the tools to do this job and can install his new fulcrum pins for you too. He lives near Dayton, Ohio.
Author

Posts

Viewing 1 reply thread

You must be logged in to reply to this topic.

/** asynchronous lucky orange tracking script will not block your page from loading. **/