My original dash had delaminated badly too, plus having a few extra holes that pervious owners added. You can make a new base to reveneer easily enough. Use marine grade plywood, finished on at least one side for a smooth surface. Use the original for a guide to routing it out, both the holes and the indentations on the back, I used a Dremel tool to do the routing, got a handle setup to allow its use as a router. Then veneer when that’s done and cut it away from the gauge/switch/etc holes.
Forums
All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below 