Dedicated to the preservation, restoration, and enjoyment of all Rootes Group Vehicles
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below 
No VIN rivets removed, just a thousand and one of these (below example from removing convertible top retaining strip and fabric at rear deck area). Do you pull them out, push them out, grind off from the back side and pop out, or what? Or do you just mash them out, weld it up, grind, and then drill new holes later?
