Just got a Bosch unit at the local auto parts store. It looks fine and installed well, but needed a caress with a press as the fan flange did not quite line up with the crank pulley. Too bad when I got it on the small print says made in Ch__a I guess I need glasses and should have seen it earlier. It was 30 bucks less expensive than the one listed at Sunbeam Specialties. The fan has had some contact with the stock fan and the middle section of the steering rack. Parts of the car look unmolested yet some have been changed the block bears the number of a 64 casting date but it is hard to say if the motor mounts were changed, looks like a shimming may be in order,the fun continues. W.
Forums
All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below 