I guess I have a regular RUG transmission as the speedo cable exits from the pass side. When someone put the hurst shifter in there was a LOT of cutting. Even hacked up the steel "hump" just in front of and between the seats. Figured I’d have to buy a welder for this project except once there is a welder , next comes a shear and then a break and then —-. Don’t want to go down that road. POP rivets anyone ? Bob
Forums
All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below 