I’m seriously thinking about the exact thing.Been thinking about it for years.This winter I hope to do both cars
If you cut the socalled bench you will need to add to the floor for the 2 or so inches.It is possible if you cut the panel high enough to bend flat to compensate for the floor.save a bit of welding.You can gain abit more by possibly slanting the upright panel.This will allow a bit more comfort room as the straight panel restricts the reclining of the seat when you move the seat back.
If you do this I would rivet the pieces together first before welding.Much easier to remove a rivet than cut a weld.
If you do go ahead and do this let me know how you make out
Forums
All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below 