Those look great. I did something like this about eight years ago when one of the welds holding the original spring pivots in place let go. However, the single gas strut I used had a LOT of pressure and I had to make an offset bracket to reduce the mechanical advantage it had on the trunk, otherwise you’d pretty much kink the lid trying to close it. Mike must have found some good struts that have more moderate lifting force.
Forums
All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below 