I find it works easiest to start at the bend over the quarter window. Slip it over the top for 6 inches or so each direction and start tapping it gently over the bottom edge with your palm or a rubber mallet. Work to one enc, then to the other, should just snap over. It will scratch the paint some on the underside of the top but that should all be covered by the stainless when complete. You may find you need to spread the bottom a little at the curve to get it started, it can be tapped back with a pointed body hammer once installed. Main thing is to go slow and easy and don’t use any hard tools that could dent it.
Forums
All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below 