Re: Weber conversion linkage – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

March 20, 2009 at 1:29 pm #62941

Jim Stone

Participant

quote SVRon:

I only have a propane torch, will that give enough heat?
PM w/address sent
Ron

I don’t think propane will do it, but you would be able to make one if you upgraded to a MAPP gas torch. I made one by brazing a piece of steel plate to a 1/4 rod, all bought at Home Depot. Light brazing is pretty much the limit of MAPP gas heat, but it will do it.