Re: Weber conversion linkage – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

March 20, 2009 at 2:50 am #62938

Ron & Linda Jones

Participant

quote mikeflbmer:

I just installed one…used the rod with 90 degree turn from the stromburgs (shortened and bent 90 degree) and then used the orig verticle rod, but had to heat and bend it in an arc to get carb to open fully…send me your email address and i can email close up pics of it…Mike

Thanks for the offer, Mike. I appriciate it. Are you saying you fashioned the Weber linkage from the Stromberg linkage? I only have a propane torch, will that give enough heat?
PM w/address sent
Ron