Re: Clutch Slave Cylinder Bracket – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

February 10, 2009 at 11:22 pm #62802

paul-a

quote tigertoms:

That’s a nice bracket you have there. It’s one of the nicest fabricated brackets I have seen. I sold my 5 bolt brackets I had several years ago. Can’t help on photo. We have a local Beam meet on teh 21st of this month. I’ll see if we can dig one up.

Hi Tom – Theo

Thanks for the feedback. It’s nice to know I have a nice slave cylinder bracket, even if it will not fit! Grrrrrrr 👿

I was quite sure that it was designed to fit as described by Theo. However, the curvature of the bracket is too tight causing the bracket to hit against the bell housing so that the mounting holes will not line up. I guess I’ll have to see if I can find one somewhere or else fabricate one that will actually work.

I found a throwout fork (clutch release lever). I now need to figure how to fasten it in place using the spring clip. The mounting bracket is in place on the bell housing and it’s obvious where the lever pivots on the bracket. What is not presently obvious is how to slide the clip in place to hold it to the bracket mount.

from sunny, windy South Dakota

Paul