I just finished refurbishing my seats….I sprayed 3m Contact cement on the top of the seat back and pillow with the pillow inside out…..then as I installed it I reveresd the inside out……then stuck the spray can in between the cover and the foam to spray 1st the back, then the front…worked pretty well….on the bottom I did similar with contact cement 1st on center double layer, then the restt of it…..securing underneath with metal clips…….Another thing I did was add A Lower lumbar suppport pillow in the seat back ….it is a hand ball inflatable rubber pillow from Moss Motors…..I glued it to the seat back foam with marine 5200 by 3m (must dry 24 hours) You cant see it when deflated and helps my back when inflated….will be grat on those road trips to TEAE uniteds…..Mike…I would attach a picture if I could figure out how…
Forums
All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below 