You shouldn’t need any special tools, other than possibly doing some welding on the seat frames if they’ve cracked or broken at the joints. Inspect them before reassembly. If you’re careful removing the original bottom cover the clips should be reusable. I’ve use a flat scredriver blade set against the exposed side of the open end end and tapped them straight off. Don’t try to lever them off, they’ll break. Compare the removed cover with the new one, you’ll probably need to poke a couple holes in them to allow the seat adjustor to fit properly. Also note that the bottom assemblies are handed, the backs are not, so you can mix and match. I’d recommend if one of the backs is better than the other and you’re not going to spend time fixing it, put the better one on the driver’s seat. Other than that just take your time, perhaps some photos, and it should go ok.
Forums
All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below 