I couldn’t find any 2 inch pipe, so I made some from sheet steel which I had plenty of. You dont really need an oval, just mark the positions where your exhaust (if you already have one) need to go first to get it central. I used an ex Tiger system. Cutting the holes was tricky, and I used a combination of power saw and power nibbler. A plasma cutter would be great I would think.
Forums
All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below 