Reply To: front springs and suspension issue

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

August 27, 2007 at 4:06 pm #61537

Owain Lloyd

thanks for those who responded to me about this.

it turned out that my link bushes were simply too tight and preventing the arms from moving freely.

i loosened them off until the washers were freely rotating, dropped the car on its wheels and then tightened just until i couldn’t not (easily) rotate the washer with my fingers.

now the car bounces correctly.

what its the correct method for knowing how tight to put these nuts? is there a torque value i can use or just some method? i suspect i may have left them too loose now.