I don’t see why one could not make a skin.If you have access to a metal shop and can use the rollers or have them roll it to match.
I would even think of attepting it for myself using a 6 inch pipe ??? or something big enough to form the curve.An air flanger could work I think to do the bending of the edge.
Of course it is easier to say it might work than making it work.
Forums
All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below 