September 1, 2006 at 8:01 pm
#60758
I just stuffed mine in a couple days ago from the top… found out just how much bigger those Trickflow heads are!! … ended up taking the valve cover off the driver’s side just to get it in the engine bay! Thinking about it after ( I used my 4 post hoist and engine hoist) I wonder if it would have gone in from the bottom without removing the cross member..and then sliding it back into the tunnel…
… spent at least 2 hours getting the motor mounts in around the headers!
I now have about a half inch beside and behind the driver’s side valve cover and about an inch above it…knew I’d never see those roller rockers again (hopefully)!
Are there ANY non stock size components on your new motor…??
Jim