May 2, 2006 at 5:24 pm
#60519
Frank
You can run a wire from the ballast resistor.Just be sure it is not the side that runs to the coil.This then gives full voltage and is most likely the simplest way to wire the choke.
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below