Reply To: Pulley alignment – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

November 2, 2005 at 11:13 pm #59935

v-mad

I just came across the specification for the dimension between mounting faces. The WSM says it should be 13 cm. I just checked my pump, and it already measured 13cm before I adjusted it (is now 12.7cm and cant go any smaller as its touching the seal). So if the WSM is correct, something is wrong with my pulley set up!

OK, so I have improved the alignment between the pulleys on the crank and water pump, and it should work OK, but I havent really found the root of the problem.

Any further thoughts?