#59854
alpine-64
Participant

    Jan Servaites has posted elsewhere about this topic.. i quote him:

    [quote="jumpinjan"] None of my labor is shown here, but would be in the range of 1500-2000 depending on my involvement with the car (I am NOT a shop):

    -PARTS PROCURED- (Engine)
    Piston set – flat tops, 0.020” $76×4= $304.00
    Bearings – 0.010”Mains $45.00
    STD Chevy rods $33.00
    Bearings, cam $24.00
    Thrust washers $18.00
    Head; In Valves 4x $15.00= $60.00
    Ex Valves 4x $15.00= $60.00
    Spring shims $5.00
    Valve guide inserts $6 eachx8= $48.00
    Water Jet $6.00
    Gaskets; Head Set $47.00
    Bottom Set $23.00
    Oil Pump $50.00
    Connecting Rod set $125.00
    Timing Chain $18.00
    Hex bolt to replace crank bolt $2.00
    Water pump $75.00
    Water outlet, thermostat (new) $36.00
    Clutch Cover $96.00 (Ian purchased)
    Clutch disc $89.00 (Ian purchased)
    Exchanges flywheels 7.5” for 8” N/C
    Alternator, Lucas ACR (plus wiring) $130
    Engine mounts, rear $23×2= $46.00
    Engine mounts, front $13×2= $26.00
    Release carbon bearing $22.00
    Misc, new grade8 hardware $20.00
    Pilot bushing $12.00
    Oil & filter $10.00
    Rubber Damper ring $8.00
    Side block drain (homemade) $3.00
    Pet cock $6.00
    Exhaust gasket, manifold $10.00
    Clutch hydraulic line (homemade) $5.00
    Clutch hydraulic rebuild kit $8.00
    Slave $66.00 (Ian purchased)
    Fan belt $15.00

    SUBTOTAL $1300

    -SERVICES- Engine
    Camshaft reground $60.00
    Lifters reground 8x $4= $32.00
    Rocker arms resurface 4x $4= $16.00
    Crankshaft reground & polish $129.00
    Chevy Rods honed for 1725pins $75.00
    Engine Block Bored & Honed $60.00
    Engine decked $40.00
    Engine block hot tanked/Magnaflux $40.00
    Head welded $60.00
    Head milled .016” $40.00
    Competition 3-angle valve grind $95.00
    Insert new guides $40.00
    Chopped Flywheel $60.00
    Balance components & fly’l/clutch $170.00
    Remove/installed exp.plugs $18.00
    Dip drive shaft $20.00
    Dipped oil pan $10.00
    Dipped side cover/ft cover/mounts $25.00
    SUBTOTAL $990
    quote]