Reply To: Edelbrock F4B troubles – TigersEast AlpinesEast

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

September 27, 2005 at 4:18 am #59761

ca-mtn-cat

Further information, I unbolted the F4B intake, removed the gaskets and checked the angles of the heads compared to the intake. they match. However, when I checked the gap for the ends of the valley I found a 1/4″ gap. I then placed the performer intake on the engine and found NO gap. I therefore I believe I found the problem. Does anyone know what gives with this manifold? Does anyone have a cure? I’m afraid to use two end gaskets for fear the the runners won’t compress enough for a good seal. HELP!!!

Hap & Patti Hazard