Neil, I am not aware of anyone making a Tiger specific set of headers out of stainless steel. Your quest makes me curious about what you are doing with your Tiger. I drive mine quite a bit in the non-winter months here in MN. Heck, I even hauled 2×6″ x 12′ long studs home this last weekend with the Tiger and it worked great (I duct taped them to the roll bar and in the passenger foot well and they rode perfectly) Anyway, short of winter driving, or in areas with high corrosion (the beach) regular headers with a good coating (Jet-Hot) last a VERY long time and cost quite a bit less than stainelss, custom made headers. I found custom headers would cost around $1000 fro mild steel, and go up from there…there is just a LOT of time involved in making headers that fit right and work well and the first set is always the most expensive.
Where are you located? I have an old set of headers that are still solid enough for patterns that you could use if needed, but I want them back in one piece. They are very similar to the headers Rick, of Sunbeam Specialties, is selling but not exactly the same.
Forums
All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below 