I’ve installed a switch on my car that is activated at the pedal. I believe it is an early chevy, 60-65 with two wires. I made a bracket that mounts to horiztal surface behind the pedal. I believe inside that box is a wet area for drainage from the vents so when I mounted the bracket I used some silicon to seal it. The wiring harness to the left of the pedals has the brake light wires in it. I think it is a green & purple striped wire for the brake light and you need a green 12v. I left the stock switch and added the mechanical. So if one doesn’t work the other one will. I also added a third brake light below my bumper. From behind you can see it but when its parked people don’t notice it. My father’s car was rear ended, one of my greatest fears.
Forums
All posts, newest on top
In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.
After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.
To edit or trash YOUR post, use the links shown below 