Reply To: What are you doing for engine venting?

All posts, newest on top

In order to add a new topic, or look through the categories, either use the drop down link (top) to Fourm Categories (shown right) or use the link to Forums Table of Contents here.

After you have chosen a Category for your new topic, scroll to the bottom of the page to find the form to add your question or comment.

To edit or trash YOUR post, use the links shown below

July 21, 2005 at 5:10 pm #59517

cleandan

quote maicoh12:

I am using the same valve covers with roller rockers and no internal baffel. The engine is 10.5 compression,single plane manifold,350hp. I use a Mr.Gasket vent baffel in the filler tube with a K&N filter on top. The other side I use a pvc valve with a filter from a brake booster between the manifold port. The car makes 12 sec. runs all night without spilling a drop.

Thanks for the input maicoh12
Is the K&N filter the style that clamps over the vent tube, or does it go inside the Mr Gasket vent baffle? On the PCV side, what “filter” are you speaking of from the brake booster. I know there is a check valve in most boosters, but I can’t recall a filter. Would you mind elaborating on your engine and cooling system build? Also, what size tires and what rear gear ratio are you running along with tranny type. I am slowly getting my Tiger in running order, but there are a few details that need attending to before I can call it reliable. Thanks again and have a great day.